Drypower 12V 7.2Ah Sealed Lead Acid Battery for Backup, Standby and Cyclic Use etc House Alarms.

Drypower 12V 7.2Ah Sealed Lead Acid Battery replaces BP7.5-12, BP8-12, EP7-12, EVP7-12, GP1272, GPL1272, EVX1272, DM12-7.2, DM12-7.5, CF-12V7.2, HGL7.2-12, FG20721, DC7-12, CB12V7.5AH, CBC12V8.0AH, NP7-12, LP12-6.5, LP12-7.0, LP12-7.2, LP12-7.5, LP12-7.8, LP12-8.5, LPC12-7.2, LPC12-8.0, LPS12-7.5, WP7.2-12, LC-R127R2P, PE12V7.2, RM12-7.2DC, RT1272, RT1275, RT1280, RT1290, CP1270, NP7-12

Multipurpose VRLA AGM batteries for superior service life and dependable performance.

Designed for constant/float backup and light cycle use in security alarm panels, emergency lighting, toys, test equipment, general electrics, automatic doors, marine power and more.

Backup & Main Power Series

• Industry leading 99.99% pure lead content for superior service life and dependable performance.
• Thicker plate design & higher percentage of tin content compared with the industry standard to maximise battery standby life by minimising sulphation.
• Suitable for use in any orientation (except inverted) for use in hard to reach or remote locations.
• Maintenance free and non-spillable design for long service life.
• 6V and 12V models available for consumer and industrial needs, from children's ride on toys to medical monitoring equipment and more.

Suitable for:

• General Purpose
• Backup Power
• Medical Equipment
• Alarm Panels
• Weigh Machines & Equipment

STEP BY STEP PROCEDURE TO CHANGE YOUR HOME ALARM BATTERIES

The majority of home alarm batteries are 12 Volt 7 Amp Hour the batteries are 150mm long 65mm wide and 95mm high, available from Batteries Direct the batteries will always be the same dimensions however the Amp Hour rating of the battery may vary between brands this does not affect the performance of the alarm.

It is a simple procedure to change the battery and can save you many $$$

When the Battery light shows it is time to replace the battery this is usually evey 3-5 years

The usual procedure to change the battery is:

1. Open the panel (the battery is usually located inside)

2. The Tamper alarm will sound

3. Enter your Pin Number this will turn the alarm off

4. Check the battery Part Number, Size, Voltage and Amp Hour rating of the battery

5. Close the Panel Re-Enter your Pin Number to set the Alarm, then in some cases again to put the alarm on standby

When you have purchased your 12 Volt 7 Amp Hour battery repeat 1-3

6. Take care not to pull on the wires when removing the battery connectors and make sure you replace them on the corresponding terminal of the new battery

The repeat step 5

CONGATULATIONS YOU HAVE JUST SAVE YOURSELF $50 TO $100.00

Terminal
F1 - 4.75mm Spade Terminals
F2 - 6.35mm Spade Terminals

Application
Cyclic - Deep cycle applications
Stand By - Stand by applications use for USP, home alarm etc
Multi Use - Can be use for both Deep cycle and Stand by applications